lap joint
英 [læp dʒɔɪnt]
美 [læp dʒɔɪnt]
（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝
英英释义
noun
- joint made by overlapping two ends and joining them together
双语例句
- When the composites are lapped in the simple way, the lap joint length has no influence on the tensile strength, but it has influence on the breaking elongation and the yield strength.
简单搭接的拉伸强度与搭接长度无关，但对屈服强度和断裂伸长率有影响。 - The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。 - Study on Laser Welding for Lap Joint of Stainless Steel 'Case
不锈钢机匣组件激光叠接焊工艺研究 - Stress Analyses of Double Lap Joint by Boundary Element Method
双搭接接头应力场的边界元分析 - A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。 - Effect of Environmental Temperature on Strain in Adhesive Layer of Single Lap Joint
单搭接接头胶层中的温度应变研究 - Based on the principle and process of laser transmission welding, the lap joint form was taken and the key technology and difficulty of welding were also considered.
基于激光透射焊接的原理和过程，采取搭接接头形式进行焊接，同时焊接关键技术和难点也被考虑。 - Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。 - The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。 - This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
本文以能量法求解无胶层厚度的搭接接头的层间应力。